Power Cable

Power Tube for Mobile Suits or large weapons. Comes in 20 pieces of metal ring tubes with a spring and a wire to guide the shape.

To apply:

1. Measure length of desired application with piece.
2. Drill a small hole enough to run the wire into the piece.
3. On the other side, tie a knot (you may need to use a sharp tweezer) to prevent it from sliding out. (Same may apply on the other end but leave it to the last)
4. On the other end, run the spring through the wire and cut excess by using a nipper.
5. Run the metal tubes through until it fills up.
6. Tie the knot to finish up.